Glass straight edge grinding machine common problems and solutions!
[Zhongbo.com] 1. The level is not level (the ground glass has large and small heads). After using the machine for a period of time, the level will be uneven. The specific reasons are as follows: 1. The foundation is soft. A solid cement foundation that has not been tamped cannot withstand the weight of the mainframe itself, causing the main engine to sink, resulting in unevenness. Need to compact the foundation and level the fuselage. 2. The glass bracket feet are not fixed. It is easy to shift when grinding large glass, resulting in differences in levels. Need to calibrate the bracket. 3, the machine used for a long time only replaces a small part of the conveyor chain block glue, the new and old block glue used together, the height is different, resulting in the polished glass has a size head. Replace all the glue or simply replace the entire conveyor chain. 4. The conveyor chain causes uneven levels. The conveyor chain that enters the glass and the conveyor chain that exits the glass are not in a straight line (not horizontal) with the front and rear platens. First adjust the height of the guide rail into the glass head (can be realized by adjusting the stroke screw screw under the guide rail), so that the 2500 long glass can be transported on the conveyor chain of the guide rail from the beginning to the end when the edge is edging (in the glass into the pressure) After passing the board 40CM, pay attention to two places: whether the glass on the conveyor chain under the pressure transmission board and the glass on the conveyor chain on the right side of the machine are still attached to the conveyor chain), if the glass on the conveyor chain below the pressure transmission board leaves If the conveyor chain is lifted up, you need to lower the rail stroke screw on the right A-frame until it is flat; if the glass tail on the conveyor chain on the right side of the machine is lifted (vacated), you need to raise the guide rail on the right A-frame. The stroke screw is flat until it is flat. The conveyor chain adjustment level on the left side of the machine is also reasoned according to this principle. Second, the head and tail or the middle can not be polished, the head and tail can not be polished. The sprocket of the bone row is displaced after the main entrance to the glass, causing displacement when the glass advances. First disassemble the two sets of hoods and correct the height and angle of the two sprocket wheels on the glass. The two sprocket wheels on the gearbox are the same. Can not be polished or polished in the middle: the front and rear platens are too loose, the glass sinks during grinding, resulting in too much intermediate grinding in the glass, resulting in no intermediate polishing or insufficient polishing. Just remove the boot shell and fasten the splint chain. Women'S Recycled Slippers,Candy Color Slippers,Flat Sandals For Women,Women Sandals Flip Flops Huaian sunrise shoes Co.,Ltd , https://www.xinruishoes.com